ford

I'm running an Anytone AT-666 with a Bulletproof Diesel NMO mount and a Laird CB27S 1/4 wave antenna on my 2020 F350. Aluminum body and a panorama roof. SWR is 1.0 on 19 with little increase on either side as 1 and 40 are both 1.2. I understand that CB usage on the roads is not what it once...

Installed a Yaesu FTM-400XDR in my 2019 Ford F150 a few weeks ago. I used a solenoid which is tied to an ignition fuse in the truck. The fuse block powers on and off with the truck. The antenna is a Diamond NR770HBNMO mounted on the front driver fender. The dash mount and behind rear seat mount...

Last summer I replaced my 2013 F-150 with a new 2019 F-150. Just like the last truck, this is my daily driver to the office job, but it does truck stuff too! I've been happy with Ford trucks and decided to get another F-150, but this time around I placed a factory order so I could get the...

I'm installing a Kenwood NX-700 2-way into a new (2019) Explorer. On this model the cable boot that runs through to the engine compartment is higher, behind the dash instruments. I'm looking for a wiring diagram on this vehicle (for power options). Or, suggestions to access the battery...

I'm looking for some instruction and guidance on installing an NMO mount on the roof of my 2019 Ford F-150. I have experience drilling through body panels and mounting antennas, but I'm not sure how the aluminum body affects the installation. I've read some threads here about aluminum Ford...

HI all, I have a 2014 ford F150 and need to know where i can get Ignition Sence from in side the vehicle. I currently have 2 Vertex EVX5400's Installed that support it and am looking at installing another radio that will also support it but i have no clue where i can get it form. Thanks

Icom ID-5100a remote head and Whistler WS-1098 install on dash with Panavise Indash Custom Indash Mount with Pedestal mount and extension bracket. Comet B-10 dual band antenna. PC tel low profile 800mhz antennas.

My setup using the Home Patrol 2 and the Larsen NMO800 antenna (I painted it Black). That antenna, though designed for 800 MHz, works quite well on Vhf Hi as well. For others looking to install an antenna, there is an existing hole through the floor with a rubber grommet under the AC inverter...

Hello All, Do any of you guys know if anyone made a radio/equipment console for a 1996 Ford F-150? Obviously it will be used but trying to get an idea of where to start. Thanks in advance!

1. Pro 197 with 800 mhz stubby antenna

My Uniden Home Patrol HP-1 mounting in my car (2008 Ford Focus)..wanted something accesible that I don't have to take my eyes off the road to look at. I had to sell my BCD 396T because it was too complicated for me....this brings back the fun of scanning...very easy and quick to use while oon...

I just got done wiring mine in today. Its an old hand-me-down I got from a family member and did some work to get it powered up. Yaesu FT-2400H Transceiver 2-meter 144 MHz mated to a brand-new Radio Shack antenna. Hard-mounted to my center console. The fused power wires go under the...

I'm trying to install a radio in a 2009 Ford F-150 and was wondering if someone can give me some help as to how to run the power cables. Do I go directly from the pos/neg on the battery, do I ground it to the frame instead, how do I get the power from the engine compartment into the cab? Or...