ic-7100

I have a hardly used Icom IC-7100 up for sale. 2meters up to 160 meters plus dstar. Comes with control head, radio, mic and a brand new controller bracket(MBA-1) I do not have the original box, I will pack it with care. $750.00 includes the ride to anywhere in the CONUS. Please no trade offers...

I'd like to avoid programming calling frequencies into each and every memory-bank — turning each 99-slot bank into a 97-slot bank; but I want my radio (which is usually scanning the known repeaters for a given area that I'm travelling in) to *also* tune past the calling-freqs occasionally, as...

WSJT-X receives FT-8 just fine, but it will not key the IC-7100 to transmit. I am using the version 2.0 beta software on a Windows 10 HP laptop and Icom IC-7100 transceiver with (or without) a Rigblaster Advantage sound card. This combination works fine with legacy JT-65 software using either...

I setup the Icom cable, and Icom USB drivers, the connected the radio. The drivers configured in two ports, but HRD can't communicate over either of them. I have a paid version of the full program in case that matters. I've tried all the suggestions that the program offered, such as try DRS...

I took my HF gear apart to put it back in a better fashion. The reason was that I installed a new LDG 1000 Pro auto-tuner and also hooked up my Ameritron amp, which I had not used in a very long time. When I was tuning the amp I would cause the radio to do a power reset. I then looked at the...

I am trying to interface my IC-7100 to the RS-BA1 remote software from Icom. I have the local software talking to my rig via Windows XP. But I run into two problems if I turn off the software or even exit it completely. First the IC-7100 microphone no longer connects to the IC-7100 unless I...

I have the shielded RJ45, and I have shielded Cat6 cable, the black one that can go outside. I don't think that matter much, but it has a tough thick outer covering and that can only be good. Has anyone made one as long as 50 feet or longer with success? Does anyone agree that the cable being...

I have WSJT-X running on my IC-7100 through a Rigblaster Advantage sound card using VOX. I would like to have the software read and display the frequency of my IC-7100 using CI-V. The software has drop down menus for various radios, but not the IC-7100. I suspect the format for the IC-7000 is...