solved

I'm running op25 on a raspi 4 from a terminal and works great, with audio going to the 3.5 mm output. When I setup op25 as a service on boot, I don't get any audio output. How can I configure this correctly? this is my op25.sh -- ./home/pi/op25/op25/gr-op25_repeater/apps/rx.py --args 'rtl' -N...

I drove all the way to Salem, NH, yesterday to pick up a new SDS-200. This morning I updated the firmware via Sentinel and purchased and installed the DMR and NXDN updates. Then I wrote the DB and FLs via Sentinel. The scanner runs for less than one minute, then turns itself off.