wouxun

Hi! Not an electric guru and I'd like to get someone wiser than me to give me "the nod" before I do something questionnable! I want a way to power a Wouxun KG-UV9D+ portable radio using a 12V lifepo4 battery, but I'm not sure how to wire things to keep it clean looking. I'm thinking of...

Is there any special charger version that works best for the UV-3D if it’s has the Lithium ion battery pack with it..? Does the UV-1P charger work fine for the higher version radios..?

I have a Wouxun KG-UV9P Series HT. When I am receiving a transmission, the radio cuts out every few seconds. The RX LED indicator and audio both cut out. They only way I have been able to get this to stop is if I have both the A and B receiver set at the same frequency. Is there a setting I...

What radio would be very useful and have great transmit and receive for either band; an LMR (type) radio or something cheap like a Wouxun or Midland? ofc both are on the same power levels (2w for MURS, and 5 to 50 watts for GMRS)

Hello I got an Wouxun KG-UV2Q. I can't switch in the cannel mode The Manual says that I will be pushe the TDR Button button for a while but nothing happens when I do this. Anyone knew this problem?

Hello all, I've got a KG-UV9D+, and am noticing that while scanning on both channels, it will sometimes run into what I can only reference as a "collision". I've narrowed down a specific example to show what I'm finding. Channel A is on 436.76500 MHz Channel B is on 406.02500 MHz Channel A...

Hey All i am using the wouxun software to program my UV9d Mate. It is very different from Chirp, in that it does not have offsets + or - or the amount of the offset in the same line as the frequency info like Chirp does. Does anyone know how to program offsets using the wouxun software? thx n

Howdy, my first full GMRS radio- wondering about the difference between the antenna and how it affects TX and RX- when to use each thanks

Hi everyone, have bought a wouxun UV2Q (updated version of UV9D PLUS) and was cheated becase the radio is described in TX from 136 to 174 Mhz and 400 to 512. However, the radio I received only works in TX from 144 to 146 and 430 to 440 MHz. Outside that small range the radio just shows “FRQ...

Hey everyone, I just bought a Wouxun KG-Uv9 ham radio. Does anyone have experience with programming it? I watched a few videos but can't figure out how to program a repeater into it. I'm trying to program a repeater using Repeater Book. If anyone knows how, can you walk me through a step by step...

Hello! I hope everyone is doing well and is safe during this pandemic. On another lighter note, recently, I invested in my first base station. It's not one of the top brands, but I think it will serve the purpose. This was purchased as a kit from Buy Two Way Radios (Ham Radio Starter Kit -...

On a whim, but with the vague aim of getting into Ham Radio, I bought a WOUXUN KG-UV950P 50 Watt Quad-Band CB Radio: https://www.amazon.co.uk/gp/product/B00J67F0YO/ Although I think it is intended for use as a mobile radio, I'd prefer to set it up as a base station if that is feasible. But...

This is a weird request so hear me out completely. https://powerwerx.com/wouxun-kg-uv9d-plus-handheld-amateur-radio Looking into buying this for ham radio use. I just got my license, and this was recommended to me as a decent entry level. Im also a volunteer firefighter. I saw this can...

I recently purchased the Wouxun KG-D901, which supports a maximum of only 2 zones. I was told by Wouxun that the radio can be updated so it can have 64 zones. However, they did not tell me how to do this. Does anyone know how to update the D901's firmware?

Hello Everyone, I was looking for some information on google about the Wouxun KG-UV9D(Plus) and I found this forum. I saw that many of you guys look to be mastering technical skills. I am sure you will be able to help me on the following issue ! :) I just bought a KG-UV9D(Plus) transceiver and...

I just purchased the Wouxun KG-UV9D and it comes with 2 antennas: 1 stubby and 1 high gain. Does the high gain antenna offer that much of a difference compared to the lower-profile stubby? Under what circumstances would the high gain be a better choice?

I'm giving up; I have a friends UV6X that I've been trying to set up for the local repeaters and a few other misc channels ... On my Boafeng I can hear the channel markers and traffic, but on the Wouxun I'm getting nothing. This radio was given to him when he got his license and is out of...

Hey Everyone...I had a couple of questions regarding the chinese two way radios such as wouxun, baofeng, etc. I'm looking for a radio that has 2/5 tone encoding, a voice (who knows what) scrambler, and possibly mdc, and other commercial features... I'm a bit confused as to the origins of these...

I'm curious as what the DPL would be for the a second frequency. My school has given me to permission to transmit on their frequency when I help out at sporting events. If you look here at Benton County School Corporation it has 1 frequency, 155.265 with a 754 DPL Benton County, Indiana (IN)...

I'm curious as what the DPL would be for the a second frequency. My school has given me to permission to transmit on their frequency when I help out at sporting events. If you look here at Benton County School Corporation it has 1 frequency, 155.265 with a 754 DPL Benton County, Indiana (IN)...