xtl 2500

Keyloading an Astro Spectra using the Kfd tool shield. I am attempting to build a connector for the w series control head mic port. Does anybody know what the sense, ground, and signal on the Kfd tool shield should go to on the w series control head mic port?

So recently I’ve been wanting to install a UCM into my XTL2500 but I haven’t been able to find any information on where the UCM needs to go in the radio. Any information on this would be greatly appreciated.

Yes I have a small addiction to Motorola. Motorola Portables: 3x XTS5000, 1x XTS2500, 1x MT1500, 1x XTS1500 1x XTS4000 Motorola Mobiles: 1x XTL1500, 1x XTL2500 ICOM: IC-7300

Ok, the Shack with the Zetron Model 27 Receiver Monitor is Complete. Purchased "BRAND NEW" with all parts and connections off of eBay. I'm so glad I went with the Model 27 vice the music/DJ style previous Mixer. The sound quality/clarity is amazing and the "Blinking" active and "Solid" Mute...

I'm working on QCII on my XTL 2500 when paging from the XTL my XTS 5000 receives fine but when paging from the XTS the audio clips out on the XTL. is it a programming issue or a hardware issue?

I feel like this is a really dumb question to ask. But am I able to take the insides of one XTL 2500 and place it in a different one?

I am looking for the following NC VIPER system information: 1. Point(s) of contact for the administration of the NC VIPER system. 2. User manual for the Motorola XTL-2500 radio. I could only find a detailed service manual PDF on the web. 3. Some general info on how the VIPER system works...

Hi, I have 2 x OEM XTL series legacy programming cables. HKN6183A (RS232 to GCAI) and HKN6160B (RS232 to rear accessory). With newer authorised CPS, my USB OEM HKN6163C cable works just fine, OEM HKN6184C works just fine on the last authorised XTL CPS with FW 8.xx onwards, but the RS232...

I'm not too familiar with the XTL family, as I am with the XTS family, and I'm trying to discover which band this XTL operates in. Below is the only information I have regarding this without actually looking at the CPS. Is there a way to find out what model this can operate in? Thank you

Can anyone provide the moto NNTN part number for XTL 2500 multi algo board with DES and others. I've found a few with different part numbers except for the last letter( a b d etc). New to UCM stuff Thanks Steve

Good evening, We have trucks with Sigtronics US-45s headsets. We are trying to tie the headset intercom system to the radio by way of the front connector of the high power radio. It is a 25 pin Dsubb/ J600 connector. I have found the pinout for the radio and is listed below: J600-1 AUX_PTT...