996p2 screen issue

[nick223]

The screen looks perfect when your looking at it from the side but head on it has black lines in the back ground. Is this signs of the screen going bad? Can you replace the screen yourself if so where can i get the lcd replacement



Thanks

 

[doctordialtone]

The screen looks perfect when your looking at it from the side but head on it has black lines in the back ground.

Did you try adjusting the brightness?

Press IN on the Volume knob.

 

[fxdscon]

The screen looks perfect when your looking at it from the side but head on it has black lines in the back ground. Is this signs of the screen going bad? Can you replace the screen yourself if so where can i get the lcd replacement



Thanks

Did you try adjusting the contrast setting?

.

 

[doctordialtone]

Yes - Both

Easier to Read BCD996P2/XT Digital Scanner Manual

 

[wtp]

Adjusting the Display Contrast This setting controls the display’s contrast. 1. Scroll to ‘Adjust Contrast’ and press E/. 2. At ‘Contrast 1-15’ scroll to the preferred contrast level and press E/ to save and exit.

Set Backlight you can also change the intensity by pressing 'VOL' to toggle your desired level to Off, High, Middle, or Low.

 

[rsgorman]

I sent my 996P2 into Uniden because the menu display was very light and no matter how you adjusted it, I could hardly read the menu. The scanning display screen was ok. Waiting on Uniden to see what the issue is.

 

[nick223]

It was a contrast setting. I never knew there was a contrast setting to make the back screen black like that. Thanks everyone