996T - Pin out/in for GPS

Status
Not open for further replies.

timkilbride

Member
Database Admin
Joined
Feb 9, 2006
Messages
1,882
Location
Linn Co Iowa
I have a Magellan GPS 310 that I would like to use with my 996T. I have four wires; red,yellow,orange, and black. Which pins do these wires go to? I have looked at the Wiki and previous messages and can't find any information on it. There is also an additional red and black wire, but these are for power via the car battery.

Thanks,
Tim K.
 
N

N_Jay

Guest
timkilbride said:
I have a Magellan GPS 310 that I would like to use with my 996T. I have four wires; red,yellow,orange, and black. Which pins do these wires go to? I have looked at the Wiki and previous messages and can't find any information on it. There is also an additional red and black wire, but these are for power via the car battery.

Thanks,
Tim K.

I am confused?

What exactly do you expect the scanner and GPS to do together?
 

timkilbride

Member
Database Admin
Joined
Feb 9, 2006
Messages
1,882
Location
Linn Co Iowa
I firgued it out. Pin 2 on the scanner is the Data In from the GPS. Pin 5 is the ground. With those two pins hooked up the scanner is reading the GPS.

Tim K.
 

rfaricy

Member
Joined
Mar 8, 2004
Messages
150
Location
Gulfport, FL
N_Jay said:
I am confused?

What exactly do you expect the scanner and GPS to do together?

Wow, where the hell have you been? The 996 is GPS-enabled. For being a senior member with, what, over 4,000 posts, this is one of the silliest posts I've ever seen.
 
Status
Not open for further replies.
Top