BCD436HP/BCD536HP: added remote command MSM

[KD9BVF]

Is there any more info on how to use the new feature

from firmware v 1.15

Added remote command MSM (MSM, nnn = Go to Mass Storage Mode for nnn seconds, then reboot to serial mode)
Thanks

 

[NYRHKY94]

See this thread, second post down. I had asked the same question a while back and never got a response. Then I saw this post and I was a happy camper. Bob at ProScan is the best!

https://forums.radioreference.com/s...tware/95044-official-software-thread-175.html

 

[UPMan]

Not really much explanation I can think of beyond the original description.


MSM,nnn <cr>


Go to mass storage mode for nnn seconds, then reboot back to serial mode.

 

[NYRHKY94]

I believe the questions (at least mine was) had to do with "how" to issue the command itself, i.e. is it only done via 3rd party software like ProScan...?

 

[ProScan]

Is there any more info on how to use the new feature

from firmware v 1.15

Added remote command MSM (MSM, nnn = Go to Mass Storage Mode for nnn seconds, then reboot to serial mode)
Thanks

See if this post by Jay911 helps. https://forums.radioreference.com/s...044-official-software-thread.html#post2935241

 

[UPMan]

You send the command to the serial port. In testing I use TeraTerm. How you use it is up to you.

 

[Jay911]

You send the command to the serial port. In testing I use TeraTerm. How you use it is up to you.

I hope you will consider bringing this to the HP1 (and related radios) too, if they're capable. It's so handy on the x36 line.