Alinco: Adding muriata and inrad filters

[stormtracker78]

I've just recently learned that I can tweak my dxr8t with better am and ssb filters from an article that nanZor and hertzian talked about in an older thread I talked to kiwa to see if they could do that yesterday they were pretty sure they could but needed the schematics and filters if it could be done im looking to turn the alinco into as much as a selective dxing r75 as possible primary is utility both cw and ssb and then am any suggestions on the filters or getting the schematics would be awesome

 

[k6cpo]

Capital letters and punctuation would make your post much easier to read and understand.

 

[vagrant]

What was the reply from Alinco when you contacted them about the schematic for the DX-R8T?

 

[stormtracker78]

[QUOTE [/QUOTE]
		They have not responded to my email yet

 

[stormtracker78]

What was the reply from Alinco when you contacted them about the schematic for the DX-R8T?

but I did contact them about two years ago to see if they could put in some upgraded filters they said it was not possible it was not designed for that but then I see that article from nanzor and hertzen who say yes it is possible and also provides pictures of where they go so I wanted to know what would be the best filter to upgrade to for SSB and CW and also the a.m. and so I can send the schematics to Kiwah so they can hopefully do it or find somebody who can

 

[stormtracker78]

but I did contact them about two years ago to see if they could put in some upgraded filters they said it was not possible it was not designed for that but then I see that article from nanzor and hertzen who say yes it is possible and also provides pictures of where they go so I wanted to know what would be the best filter to upgrade to for SSB and CW and also the a.m. and so I can send the schematics to Kiwah so they can hopefully do it or find somebody who can

Oh and sorry for the punctuation I'm using voice as my right side sprained a little bit so hard to type