SDS100/SDS200: Battery low setting

[scanman1958]

I was wondering if there is a battery factory preset voltage setting that either turns off the scanner or allows the low voltage beep and icon to flash. I know a setting can be changed for low voltage. If so, what would be a good setting to give me the most out of the battery?

 

[doctordialtone]

I was wondering if there is a battery factory preset voltage setting that either turns off the scanner or allows the low voltage beep and icon to flash. I know a setting can be changed for low voltage

Easier to Read SDS100/200 Digital Scanner Manual

 

[scanman1958]

Thanks for the help. The info states the setting range is 3100 to 3400 and the default is 3300. I have not touched the settings and my scanner is set at 3500. Interesting.

So if I set the voltage to, let's say, 3200 will the scanner operate for a longer time before the alert sounds. (That's assuming the battery is at full charge)

Thanks

 

[Ubbe]

Scanner will always turn off at the same battery voltage. You only set the warning beeps voltage. A high value will warn when there's a couple of hours left of battery life and setting the voltage to the lowest setting will only let the scanner work for 10-20 minutes after the warning beep are heard.

/Ubbe

 

[scanman1958]

Aha. Thanks so much.