SDS100/SDS200: CB Frequency Favorite List doesn't scan

[Utahscan12]

Hello Everyone,

I have a Uniden SDS100. Just updated the database with the sentinel software program and added CB radio channels for the first time as a favorites list. WROTE TO MY SCANNER.

I cannot get the channels to scan automatically. When I go into the list, it will say nothing to scan. But if I do hit the.CHANNEL soft key it will show all of the channels, but I can only scan them manually? Paragraphit will show all of the channels, but I can only scan them manually?

I’ve attached the two different screens that I see. The blank one is when I first choose the list to monitor, which shows nothing. Then the screen I get if I press on the channel key. Then also a screenshot of what it looks like in my.Sentinel Software

Any and all help will be greatly appreciated

 

[hazrat8990]

Make sure you don't have location control turned on for that list.

 

[Computrguy]

Hmmmm, lots of threads on "Nothing to scan" message. I know there is a checklist one can use when one comes across this problem.
I used the db to make my FL for CB while I travel.

 

[engine183]

You might want to do a quick of all your "Service Types" Be sure that are checked!

 

[jtwalker]

You might want to do a quick of all your "Service Types" Be sure that are checked!

Specifically service type “other”.

 

[ofd8001]

I've created a Favorites List for just CB frequencies and it works fine. Most likely your problem will be one of the items in the "Nothing to Scan" checklist:

X36 "Nothing to Scan" Checklist

X36HP "Nothing to Scan" Checklist Scanner Checklist: 1. A location has to be set in 'Set Your Location' to monitor the Database. 2. You must enable at least one Favorites List or the Full Database in 'Set Scan Selection>Select Lists to Monitor'. 3. Favorites Lists or...

forums.radioreference.com

 

[enosjones]

make sure avoid is off and u have the favorite list number enabled to scan, the quick key turned on and location off

 

[Cameron2828]

Like was said earlier, make sure the service type is ON that matches what you are listening for.