• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

CPS 2.0 Error Code #101005 (Again...)

R

rkumetz

Member
Joined
Sep 3, 2015
Messages
53
I have some ctb code plugs that I am trying to read into CPS 2.0 and I am getting the dreaded #10100r Code plug version not supported error.

I previously had this problem when I set up a new laptop and Moto support revealed that you need to have CPS 16 installed to read the
retro .ctb files. I installed it and the problem went away.

Then I tried to open these files and I seem to be back to square one. I can read them with CPS 16 but I don't have a 25khz entitlement
set up with that software (well I did on an old computer but that is yet another issue) so I would like to be able to make my changes
and save them as .ctb2 files.

Any ideas?

​

 
You must log in or register to reply here.

Similar threads

H
XPR I need help with reading a XPR 6300.
Replies
8
Views
406
merlin
merlin
M
XPR5550 Firmware Update Help
Replies
11
Views
679
mapper65
M
F
XPR Region not Supported, but Region is Correct for CPS
Replies
1
Views
417
KJ4DHF
K
N1SQB
HT1250 Warris CPS Question!
Replies
1
Views
259
ff026
F
Squadman35
APX 7000 Conventional Simulcast - Call Alert Question
Replies
8
Views
602
ramal121
ramal121
Top