SDS150: Cup holder mount

[audiotechguru]

You can build your own with Bullet Point Mounting..

Radio Holders

Securely mount your handheld radio, CB radio. hand mic or Magnetic Mic™.

www.bulletpointmountingsolutions.com

 

[phask]

Cup Holder Mount for SDS-150 by MikeWdotorg

This is a recessed cup holder stand, it's designed to set deep in the cup holder and angle the SDS-150 slightly so you can see what's going on. It is not compatible with the SDS-100. This is a friction fit, but primarily grabbing the battery by the rails. I printed mine in PET-G, and I suggest...

www.thingiverse.com

I find it just a bit tight but its sturdy. That could be adjusted in the 3d file though. Which I might try.

I printed this for WA8PYR, ABS on a P2S.

Video here fwiw

 

[phask]

Thanks, I’ll check that out and see if I can track down someone with a 3d printer.

Printed - here is a vid of it

 

[frazpo]

Printed - here is a vid of it

The video is labeled as private and unviewable.

 

[phask]

The video is labeled as private and unviewable.

It should be live now, one has to set a "go live " time, had not got there yet Let me know if still not viewable - I rarely post to Utube.

 

[wa8pyr]

I printed this for WA8PYR, ABS on a P2S.

Video here fwiw

Thanks! I'll be in touch this weekend; hoping to make it over that way later next week (after the dang taxes are done and submitted).

 

[swiper1911]

I have the Lido cup mount for the SDS150, but I'm considering replacing it with a Ram cup mount.
What I personally don't like is how the radio with rock side to side when I take a turn. Which would be ok, if I was just using a rubber ducky.
But I doubt my SDS150s antenna solder joints would appreciate it once I have a cable running to it.
So I'm considering the more solid Ram mount for this reason.