Unitrunker Need help on Unitrunker

[RollingRocker]

Why does this box continually vary in numerical value from ~0 to 70, and mostly hover around 40-50? I am about 3-4 miles from the antenna with direct line of sight. Is there a good guide to help me optimize my setup? Is it normal behavior for the green bar to fluctuate constantly?

 

[dave3825]

It represents signal health. What you need to do is get your dongle on frequency. .




Go down to the Warp section, and enter a value either up or down. For down, you need to enter the minus before the value. Watch your signal. Keep changing it until your signal looks centered.

 

[maus92]

Adding that you should change the Warp setting until the Window value is as close to zero as possible - your screenshot shows 59.

 

[RollingRocker]

@dave3825 @maus92
I adjusted the warp to -1, and now the green bar is pretty much staying on 100, and window goes from -3 to 0. Is this better?

 

[maus92]

@dave3825 @maus92
I adjusted the warp to -1, and now the green bar is pretty much staying on 100, and window goes from -3 to 0. Is this better?

Yes. Window values within +/-10 of zero is good, with zero being perfect.

 

[devicelab]

Isn't this the old Unitrunker? The new version supports SDRs directly.

 

[dave3825]

Isn't this the old Unitrunker?

No.