BCD436HP/BCD536HP: Nothing to scan

[JoplinFossil]

Would someone be willing to look at the enclosed file and tell me what's the matter. I had this working this working this morning but somehow have messed it up. I have gone back and compared it to some of my working ones but can't see what I've done. I keep thinking it's in my Quick keys.??????

 

[JoplinFossil]

Service types have been enabled, monitoring and download is on. Checked the RadioReference on nothing to scan but can't see anything wrong. I have other programs that will run but I have them turned off trying to figure this out. I feel it's something simple.

I think I found it for some reason under System Quick Key there was a (.) instead of a 0. Have no idea. I'll have to wait till there is some traffic to see if it works but at least it's scanning now.

 

[ka3jjz]

You didn't say anything about for what scanner this is and what software that file uses, so it's a little more difficult to diagnose it. However our wiki has an extensive article on this popular problem

Nothing to Scan - The RadioReference Wiki

wiki.radioreference.com

Mike

 

[VK3RX]

It sounds like a quick key issue. I see you have "0" assigned to "All".

Press the "0" (zero) key.

 

[JoplinFossil]

Using Proscan and Sentinel on BCD436HP.

 

[ProScan]

Would someone be willing to look at the enclosed file and tell me what's the matter. I had this working this working this morning but somehow have messed it up. I have gone back and compared it to some of my working ones but can't see what I've done. I keep thinking it's in my Quick keys.??????

You have a Department Quick Key assigned "0" and you have only 1 department. You could set that to None and write to the scanner and see what happens or you could turn on DQK 0 if it's off. Also confirm that the Schools Service type is set in the scanner. That may not matter if you used ProScan to write to scanner and you selected "Turn On Service Types..."