Pro-2035 Reset

[Thunderbolt]

How do you completely clear the contents of a Pro-2035 so all of the channels are blank?

73's

Ron

 

[pro92b]

RESTARTING/RESETTING THE SCANNER

If the scanner's display locks up or the scanner does not work properly
after you connect power, you might have to restart or reset the scanner.

Restarting the scanner clears and resets the scanner's display, but does
not erase any channel information stored in the scanner's memory. Follow
these steps to restart the scanner.

1. Turn off the scanner, then turn it on again.

2. Insert a pointed object such as a straightened paper clip into the
RESTART hole on the back of the scanner for about 2 seconds.

If the scanner still does not work properly, you might have to reset it.

CAUTION: This procedure clears all the information you have programmed
into the scanner. Use this procedure only when you are sure the
scanner is not working properly.

1. Turn off the scanner, then turn it on again.

2. Press and hold down CLEAR and insert a pointed object such as a
straightened paper clip into the RESTART hole on the back of the
scanner for about 2 seconds. Information on the scanner's display
disappears.

3. When information reappears on the scanner's display, release CLEAR.

 

[Thunderbolt]

Thank you Pro92b!

73's

Ron