Forgive me if this is an old question. I thought I saw this issue on the forum awhile back, but when I searched the messages I wasn't able to find an answer.
I just installed BC VUP Version 3.00.01. I'm rying to install the Version 1.07.03 firmware in a BCD996XT and I keep getting a "The scanner doesn't respond . . ." error message.
* Note that FreeSCAN communicates with the scanner just fine using the same com port and same cable plugged into the front jack of the 996. (Yes, I checked, the com port numbers are the same in both programs.) Do I need to set the scanner to a particular port speed for BC VUP to work? Some other issue?
Thanks in advance.
Dan
I just installed BC VUP Version 3.00.01. I'm rying to install the Version 1.07.03 firmware in a BCD996XT and I keep getting a "The scanner doesn't respond . . ." error message.
* Note that FreeSCAN communicates with the scanner just fine using the same com port and same cable plugged into the front jack of the 996. (Yes, I checked, the com port numbers are the same in both programs.) Do I need to set the scanner to a particular port speed for BC VUP to work? Some other issue?
Thanks in advance.
Dan