SDS100/SDS200: Signal pulses after firmware update

[Isinglass311]

I updated both of my SDS200’s and my SDS100 to the latest firmware version 1.23.15 a few days ago. On both 200’s I get a pulse between the audio dropping and the delay expiration. I have my delays set to 5 seconds. The SDS100 does the same thing but without the audible pulsing, just the pulsing of the signal bars. It seems to do this only on P25 transmissions. Anyone else notice this? Here’s a link to a short video of the issue on my YouTube channel.

All the best,
Joel

 

[faojk911]

I’ve experienced this as well. There is a discussion already in this thread:

SDS100/SDS200: - Clicking Noise SDS 200

Being concerned what the future might hold for tariffs, I ordered an SDS 200 which arrived today. It was programmed and the firmware updated to the current release. The good news is that I am receiving things from adjacent counties that the 536 that it replaced, did not. The bad news is that...

forums.radioreference.com

 

[Firebell2110]

I’ve experienced this as well. There is a discussion already in this thread:

SDS100/SDS200: - Clicking Noise SDS 200

Being concerned what the future might hold for tariffs, I ordered an SDS 200 which arrived today. It was programmed and the firmware updated to the current release. The good news is that I am receiving things from adjacent counties that the 536 that it replaced, did not. The bad news is that...

forums.radioreference.com

Makes me not want to get one of these then because my SDS 100 does not do any clicking noises must be just only to the mobile units then that this applies to except I'm missing certain transmissions from time to time or the become garbled on occasion error rates are low at least zero to one when I look at it other than that I tried looking at the antenna connection. My antennas are fine. Must be in a bad spot of my house then.

 

[nessnet]

Makes me not want to get one of these then because my SDS 100 does not do any clicking noises must be just only to the mobile units then that this applies to except I'm missing certain transmissions from time to time or the become garbled on occasion error rates are low at least zero to one when I look at it other than that I tried looking at the antenna connection. My antennas are fine. Must be in a bad spot of my house then.

itsoundsliketheclickingisonlyonconventionalP25soifyouonlylistentotrunkingyoushouldbeok