New TRX-1. Programmed with EZ Scan - latest version from website. Also latest firmware updates.
1) On some DMR entries - I have encrypted option set to TONE but when the scanner stops on that entry all I hear is garbled voice. I assume that if it was encrypted, I would just hear a tone. I am close enough to have full signal strength. Am I interpreting this correctly?
2) There are instances in this area where the same freq is used for analog and DMR. The freqs are separate entries, one DMR the other Analog. Is there a way (with no PL tone) to stop the DMR noise on the analog entry?
3) On the Sq Exclude feature - anyone understand how to implement it? How to exclude a certain PL from an entry? Manual mentions the feature, but I haven't seen anything that actually explains how to implement it.
4) Maybe this will help someone: At times, I've had issues reading or writing to/from the scanner - I get a message that says Waiting For SD Card Availability. I would look at Computer (running Win 10) and see that the TRX-1 drive was showing, but it wasn't showing the "scroll bar" under it like the other drives that shows how much space is used/available. If I right-click on the Computer window and hit refresh, the scroll bar will re-appear. Then the read or write works just fine.
Thanks for any assistance!
1) On some DMR entries - I have encrypted option set to TONE but when the scanner stops on that entry all I hear is garbled voice. I assume that if it was encrypted, I would just hear a tone. I am close enough to have full signal strength. Am I interpreting this correctly?
2) There are instances in this area where the same freq is used for analog and DMR. The freqs are separate entries, one DMR the other Analog. Is there a way (with no PL tone) to stop the DMR noise on the analog entry?
3) On the Sq Exclude feature - anyone understand how to implement it? How to exclude a certain PL from an entry? Manual mentions the feature, but I haven't seen anything that actually explains how to implement it.
4) Maybe this will help someone: At times, I've had issues reading or writing to/from the scanner - I get a message that says Waiting For SD Card Availability. I would look at Computer (running Win 10) and see that the TRX-1 drive was showing, but it wasn't showing the "scroll bar" under it like the other drives that shows how much space is used/available. If I right-click on the Computer window and hit refresh, the scroll bar will re-appear. Then the read or write works just fine.
Thanks for any assistance!
Last edited: