Unication G4 pager set up for AFRRCS

[woodie9]

Does anyone have information on Setting Unications G4 pagers for AFRRCS P25 systems?

I am struggling to get my head around where I set up the zones/channels.
My intent is to have my county station pagers each with 3 zones
Zone - Cnty Disp 1
Cnty Disp 1 All = no tone
Stn 1 = Tones
Stn 2 = Tones
Stn 3 = Tones
Stn 4 = Tones
Stn 5 = Tones
Stn 6 = Tones

Zone - Cnty Disp 2
Cnty Disp 2 All = no tone
Stn 1 = Tones (different from above)
Stn 2 = Tones (different from above)
Stn 3 = Tones (different from above)
Stn 4 = Tones (different from above)
Stn 5 = Tones (different from above)
Stn 6 = Tones (different from above)

Zone - Working
Working 1= No tones
Working 2 = No tones
Working 3 = No tones
Working 4 = No tones
Working 5 = No tones
Working 6 = No tones

Any help greatly appreciated!!

 

[kayn1n32008]

With out an affiliated radio sitting on the paging talk group, on the site you are in range of, you won't receive pages.

 

[hazrat8990]

How far have you made it with your profile? On tab E2, have you at least managed to add sites and talkgroups? Have you added any sub-groups with their tones? If so, tab E7 is where you set up zone and knob positions. As long as there is an established system, you will be able to add TG's to each knob position, as well as specific behavior of the knob.

Check your messages.

 

[woodie9]

How far have you made it with your profile? On tab E2, have you at least managed to add sites and talkgroups? Have you added any sub-groups with their tones? If so, tab E7 is where you set up zone and knob positions. As long as there is an established system, you will be able to add TG's to each knob position, as well as specific behavior of the knob.

Check your messages.

I have tab 2 set up correctly
my understanding is that each tab set up for the next, however, I seem to be going down a rabbit hole