unitrunker help

[vinsky]

Ok I changed my second 996XT for a BCT15X and now I got the scanner responding to the park freq. But I can't hear anything even if the signal scanner is on the Edacs control channel

 

[SCPD]

What's your listening priority threshold?

What are the assigned priorities of the talkgroups you want to hear?

 

[vinsky]

The most talkgroups I wanna hear is the police.

I have a few tgrps set to 1. Can I set them all to priority one?

Also. It's a new BCT15X and when it responds to the park frequency it sudenly starts quich searching. Do you know how can I disable it?

When it goes in quick search mode, unitrunker follows the frequencies. I'm searching over the internet to fix it but nothing found yet.

 

[SCPD]

The most talkgroups I wanna hear is the police.

I have a few tgrps set to 1. Can I set them all to priority one?

Priority scanning is a whole discussion to it's own. If the voice receiver is following one call when a more important call comes through, the less important call is preempted to follow the more important one.

Also. It's a new BCT15X and when it responds to the park frequency it sudenly starts quich searching. Do you know how can I disable it?

I don't understand this comment.

When it goes in quick search mode, unitrunker follows the frequencies. I'm searching over the internet to fix it but nothing found yet.

I don't understand this comment either.

 

[vinsky]

Ok just forget about the two last comments. The scanner goes in quick search mode when controled by unitrunker it's normal I guess.

It works now THANKS A LOT Unitrunker!!!

Now I would like to send the audio back to the computer to listen to the Provoice groups. Do I need 1 more sound card?

 

[SCPD]

The command sent to the radio is QSH or Quick Search Hold.

Yes. You'll need a second audio input. Technically you have stereo input but I don't know if DSD will share an audio port while decoding only the left or right channel.