Windows 10 audio

[moonbounce]

I have been noticing that when I use Windows 10 with say for example Unitrunker V1 and DSD+1.101 that a lot of the radio transmissions are not picked up. I have the Unitrunker and DSD+ setup on two different computers, one with Windows 7 and one with Windows 10 and Windows 7 doesn't miss a beat when it comes to playback of the received signal, where Windows 10 will not produce audio in DSD+but it will be scrolling. Both computers are Lenovos, one is a t420 the other is a t430.

MB

 

[jonwienke]

More likely RFI affecting signal detection/decode than OS version.

 

[Whiskey3JMC]

If you're technically inclined, swap the hard drives. Install the Windows 10 drive into the laptop that doesn't have the issue (since they are both Lenovos I wouldn't anticipate any issues with the boot up) This will rule out a potential hardware issue with the other laptop

 

[moonbounce]

Actually my Lenovo t420 with Windows 7

If you're technically inclined, swap the hard drives. Install the Windows 10 drive into the laptop that doesn't have the issue (since they are both Lenovos I wouldn't anticipate any issues with the boot up) This will rule out a potential hardware issue with the other laptop

Actually I use my Lenovo t420 with Windows 7 for all my DSD+ and SDRSharp functions, the Windows 10 computer the t430 is for the internet only, I do have it set up the same as the t420 though. My reason for posting this message was that I wouldn't have even noticed the problem if I hadn't had both systems running at the same time monitoring the same frequencies, and I was wondering if anyone else had noticed the same.