Yaesu FRG-9600 Computer Control

[k2gtm]

Hello all,

Does anyone know of any freeware Windows 10 software (or something that will run in Windows 10) that will control a Yaesu FRG-9600 receiver? I have one and I'd like to use it, but I'd prefer to program it with a PC, if possible.

Thanks!
- Greg

 

[n6ect]

CAT TEST PROGRAM

Cat Test Program - Yaesu FRG-9600 Service Manual [Page 4]

Yaesu FRG-9600 Manual Online: Cat Test Program.

www.manualslib.com

Partially covered lines read:
1010 PRINT “INPUT FREQ. (MHZ)”
1020 PRINT “ FREQ. RANGE 60.0 - 905.0 (MHZ). “ : PRINT

CAT SYSTEM PROGRAMMING ADDENDA

Cat System Programming Addenda; Operating Manual Errata - Yaesu FRG-9600 Service Manual [Page 5]

Yaesu FRG-9600 Manual Online: cat system programming addenda, Operating Manual Errata.

www.manualslib.com

 

[N8YX]

Thread bump:

You might check out ScanCAT Gold. Unless you have an older dedicated PC that runs XP, you'll have to run it in a VM but IIRC it supports the -9600.

 

[majoco]

You'd be hard pushed to find a computer running BASIC these days.

 

[N8YX]

You'd be hard pushed to find a computer running BASIC these days.

Tandy model 100/102 and 200, for starters.

Several of them here. They work just fine for their intended purpose and can control most things with a serial port...assuming the owner is up for a little coding.

 

[stevetech99]

Whilst I haven't tried it yet due to waiting for my cable to be delivered, CubicSDR features rig control and will control the FRG 100, 8800 and 9600 radios. It is cross platform and can be found here . It also supports a whole host of other radios so my be a good choice for many of the legacy platforms that are no longer served by their original software.