WIN500 heap error

[hpycmpr]

I seem to have messed up royally. I'm getting a "heap error 25FC1F: 2603" whenever I push MAN or WX or a few other buttons on the 500 and 600.
Also, related or not, my trunked TG's are no longer associated with several of my TSYS's. I can scan but nothing else is functional. HELP!
Steve

 

[W6KRU]

I seem to have messed up royally. I'm getting a "heap error 25FC1F: 2603" whenever I push MAN or WX or a few other buttons on the 500 and 600.
Also, related or not, my trunked TG's are no longer associated with several of my TSYS's. I can scan but nothing else is functional. HELP!
Steve

That is causing the heap errors. Fix the TGs that aren't associated with a TSYS and the heap errors will go away.

 

[hpycmpr]

And how do I do that without downloading the trunk systems all over again? Or is that the best method?
Steve

 

[W6KRU]

And how do I do that without downloading the trunk systems all over again? Or is that the best method?
Steve

You can click the Show unassigned checkbox in the upper right corner of the TG pane. Then select all of the the TGs that are not associated with a TSYS. Then do a cut. Click the unassigned checkbox again and paste into the pane for the appropriate TSYS.

 

[hpycmpr]

Thanks Dan. That was a slight variation on some things I had tried and the scanner is looking better than it has all day. Unfortunately I'm not where I can verify it. It was my Wyoming trunk systems that were unassociated and I'm out of range right now. By mid week I should know. I'm slowly learning what not to do.
Many thanks for your help.
Steve