btech

* I chose the anytone prefix as the btech 6x2 is essentially the same as the Anytone 868. Hello all, I'm not sure if anyone else has had the same issue or not, but on my btech 6x2, after every dmr transmission from someone on a talkgroup, there's a hi-low end of transmission tone. It doesn't...

I recently installed a Btech 50 watt radio with a Tram 1181 antenna on an MNO mount. I've double-checked that everything is grounded properly, and while the radio transmits just fine, the reception is absolutely plagued with noise. Here's the weird part: if I completely remove the antenna from...

So I just purchased this mobile ham radio and have been enjoying it a lot. 25 Watts, had it programmed for repeaters in my area and all of a sudden, the display is very dim, no volume, hand mic is not functioning at all and does not even light up, the screen flickers when I’m on a frequency that...

I am receiving interference on a one-way listen-only analog frequency on a BTech DMR-6X2 Pro while sitting at my desk. It makes squelching noises intermittently and then just stops. This happens nowhere else so far. Are there settings I can change to be able to sit on the channel without...

Literally just purchased this radio. I like the features offered and I like the options the software gives. I have downloaded the CPS and ALL drivers for this cable. The radio seems to acknowledge the download and everything says it acknowledges and has been completed. But when the radio...

I have a BTech UV25X2 that has worked quite well for about 2-3 years. Recently, the received audio has disappeared. When I power up, the "Start" tones sound normal, so I know the speaker is working, but I cannot receive any transmitted audio. I've transmitted from a nearby HT, I've tried...

I am traveling across the country from CA to FL next week using the southern route. I am looking for a Chirp file for my BTECH UV-5XR that will have many of the proper emergency, local & repeater channels programmed already. I understand some will overlap from one state to the next, but I was...

Hi guys, newbie again. I have a question. We as a lifeguards use the UV50X2 now for a couple of weeks. But my co lifeguards cannot seem to get a hold of the idea that the transciever can be on multiple channels. This results in them being on the wrong channel. So is it possible to change the...

I have purchased a Btech GMRS-V1 and am trying to get it to work with my cobra micro talk cxr900. I have set the frequency to 16 DCS 6 on the micro talk. The GMRS-V1 is setup with DCS 0043N for both TX and RX. When I key the micro talk up, it breaks the squelch on the GMRS-V1, but when I key...

I recently wrote a review of the BTECH GMRS-V1 handheld radio for my club’s forum, and after using it for a few months I would like to share my thoughts here as well. The original review can also be read on my blog. I was in the market for a handheld GMRS radio to be used primarily for outdoor...