damage

Hello all. This is my first post after lurking for a long while. I currently use an SRX2200 AN Model 1.5 radio and recently it was dropped from a fair height directly onto the volume knob. The result was the knob and the connector to the knob (including the spanner) was disconnected from the...

on my roof are 4 antenna... a 4010 EFHW and a 10m/6m/2m/70cm vertical, attached to my IC7100 a dual band 2m/70cm, attached to my FTM400. and a tram 1411 discone for my Pro197 they are all at least 8ft apart. the base of the discone mast is a few feet lower on the roof than the rest which...

I can not believe what I have had to endure with Uniden Scanner support, Back in April June I sent in my 396 XL to be repaired there was an issue where the power button was not responsive and the uinit was not functioning properly, I paid my $69.95 finally got my unit back, seemed like the...

I interchange antennas frequently on my sds100, and I was wondering if there are any adapters that I could put on that will take the damage and wear over time, rather than the scanner itself.

I recently dropped my Bearcat BC125AT scanner from my desk and onto the floor. When it fell I also accidentally ran over the top of the antenna with my chair although I picked it up quickly. My question is if there is a possibility that the scanners hardware was damaged or there are any...

I just thought I would start a thread to get damage reports from the various areas. I am in Litchfield CO working in Bristol. The Bristol area was hit hard and part of the town was under mandatory evac notice for most of the day. Memorial Blvd has been closed most of the night due to over...