Additional Help with P25 GO transit programming - BCD396T

[VE3RADIO]

Hey Everyone!

I have read all of the previous posts in regards to programming the GO transit system. I believe i have set the offset and such correctly.

Here is my question, I noticed there are several control channels for GO transit, I have put in the primary and secondary channels in to my scanner... here are some screenshots below:

I find that the signal is somtimes weak for GO Transit... Do I need to have all of the control frequencies in my scanner? Should they all be in one system? or should i make a seperate system for each site?

Thanks for the help!

 

[VE3RADIO]

or should my setup look like this:

 

[EJB]

You dont have to worry about the bandplan on a 396 for this s ystem.
Set it as a Mototrola APCO25 system. No offsets required.

The signal can be weak.
Program in all the channels

0413.5625
0410.5375
0411.0375
0410.0625

 

[VE3RADIO]

Thanks.. thats what i thought.. worked like a charm.

by the way.. are my questions descriptive enought? I read as much as i can before asking.. Perhaps we could make a KB,, (other than the wiki)

 

[EJB]

I understood you.
It wasnt hard to for me.