BC125AT search question

Status
Not open for further replies.

airwolfbell222

Member
Premium Subscriber
Joined
Dec 26, 2009
Messages
173
Location
New Hampshire
I was wondering on the BC125AT if you can

1. Change the modulation mode on on custom or factory programmed searches (ie. NFM, AM, ect.)

2. Change the steps on factory programmed or custom searches (ie. 25 kHz/50 kHz, ect.)

Thanks!
 

captclint

Mentor
Premium Subscriber
Joined
Dec 31, 2005
Messages
2,452
Location
Mountaintop, PA

TedRHayes

Member
Joined
May 19, 2004
Messages
253
Location
Beavercreek, Ohio
Unfortunately there appears to be no way to change the Modulation (NFM/AM) or step size during Service or Custom searches in the BC125AT from the bandplan defined in the firmware.

This is a little frustrating since there is a lot of MILAIR traffic in the 136-142 band in AM mode, but the bandplan defaults to NFM.

One can program a scanned channel (1-500) to a modulation different than the bandplan.
 

airwolfbell222

Member
Premium Subscriber
Joined
Dec 26, 2009
Messages
173
Location
New Hampshire
That's what I was afraid of, thanks for the info!


Unfortunately there appears to be no way to change the Modulation (NFM/AM) or step size during Service or Custom searches in the BC125AT from the bandplan defined in the firmware.

This is a little frustrating since there is a lot of MILAIR traffic in the 136-142 band in AM mode, but the bandplan defaults to NFM.

One can program a scanned channel (1-500) to a modulation different than the bandplan.
 
Status
Not open for further replies.
Top