BCD325P2 programming help

[beckytwister]

I can't figure out how to program this. All my others have been done with a computer which I do not have now. Any help?

 

[tvengr]

See if this helps: Easier to Read BCD325P2 Digital Scanner Manual

 

[wtp]

i sent a personal message with some barebones manual programming to get started and hear something.
look at the top right of this page for the little envelope.

 

[jtwalker]

I’d suggest one of the following:
1) get a computer
2) borrow a computer
3) get a new hobby

If you are programming more than ~20 conventional channels I’d forget about doing it by hand without a computer and software. Possible yes, but way too much of a headache.

 

[RandyKuff]

You can post in your state forum and see if there is somebody close to you that can help you out...

Indiana Radio Discussion Forum

Forum for discussing Radio Information in the State of Indiana.

forums.radioreference.com

 

[ka3jjz]

There are numerous resources to help you learn, including videos at the bottom of

Uniden DMA Resource Page - The RadioReference Wiki

wiki.radioreference.com

Mike

 

[Whiskey3JMC]

Get a computer, invest in Proscan & a Radioreference Premium Subscription to utilize RR's web service. Believe me it will make programming much much easier than doing so by hand. Plenty of resources right here on the forums & lots of folks here willing to lend you a guiding hand. Welcome to the RR forums!

 

[RandyKuff]

My question to the OP is...
If you don't have a computer what are you using to post here, your cell phone?

 

[tvengr]

Get a computer, invest in Proscan & a Radioreference Premium Subscription to utilize RR's web service.

It is so much faster and easier using programming software than doing it manually with the scanner menus. You can also use Butel ARC-XT software to program your scanner. Both ARC-XT and ProScan have a free trial period to decide which one you like better. I use ARC-XT Basic to program my BCD325P2.

 

[beckytwister]

It is so much faster and easier using programming software than doing it manually with the scanner menus. You can also use Butel ARC-XT software to program your scanner. Both ARC-XT and ProScan have a free trial period to decide which one you like better. I use ARC-XT Basic to program my BCD325P2.

Thank you I appreciate that