SDS100/SDS200: Conventional Transmissions getting clipped

[tnbound]

I have the SD200 and my Conventional transmissions are getting clipped as soon as the scanner stops on a signal and someone starts transmitting. I am running DND Priority with 2 second interval. I have tried it every way and cannot get it to stop happening. I had this problem a long time ago and forget what solved it. I have read Marks easier to read manual and nothing seems to work. I was hoping someone may have had this happen before and can point me in the right direction? I forgot to add I am using the Sentinel software.

 

[jtwalker]

Turn off all priority modes, even a DND. I bet problem goes away.

 

[wtp]

squelch set too high ?

 

[dmfalk]

Don't forget to check WX Priority, too.

 

[tnbound]

Turn off all priority modes, even a DND. I bet problem goes away.

That didn't stop it

 

[tnbound]

squelch set too high ?

Squelch is always set to two

 

[tnbound]

Don't forget to check WX Priority, too.

Weather Priority is off. I had to check because I never us e the weather on this radio

 

[jtwalker]

That didn't stop it

Close Call off also?

 

[tnbound]

Close Call off also?

Yes just checked that also. Still not working

 

[dmfalk]

Check your delays, then. If they're in the minus number of seconds, they'll cut off.

 

[KevinC]

Are you connected to ProScan while it’s happening?

 

[tnbound]

Check your delays, then. If they're in the minus number of seconds, they'll cut off.

Delays are all good

 

[tnbound]

Are you connected to ProScan while it’s happening?

Yes I am

 

[KevinC]

Yes I am

Check resume delay (?) in the upper right hand corner. Should be a drop down menu.

 

[tnbound]

Check resume delay (?) in the upper right hand corner. Should be a drop down menu.

That's was it. Your the man! I used that today actually. Wow I was pulling out what little hair I have left. Thank you guys for all the input.

 

[KevinC]

That's was it. Your the man! I used that today actually. Wow I was pulling out what little hair I have left. Thank you guys for all the input.

You’re very welcome.

 

[ProScan]

That's was it. Your the man! I used that today actually. Wow I was pulling out what little hair I have left. Thank you guys for all the input.

Same issue two years ago.

SDS200/Wifi and Proscan - probably a computer or router issue

Issue started yesturday when I disconnected the Ethernet Lan cable, power and antenna to move the radio a couple feet. I put it all back together again and if the Lan cord is disconnected from the scanner it receives transmissions perfectly. But if I plug the Lan cord in and open the squelch...

forums.radioreference.com

 

[tnbound]

Same issue two years ago.

SDS200/Wifi and Proscan - probably a computer or router issue

Issue started yesturday when I disconnected the Ethernet Lan cable, power and antenna to move the radio a couple feet. I put it all back together again and if the Lan cord is disconnected from the scanner it receives transmissions perfectly. But if I plug the Lan cord in and open the squelch...

forums.radioreference.com

Yes that was probably the last time I had an issue with that Bob. I enter quick frequencies in there from time to time but never messed with the resume Scan/Search speed before until today. Just another senior moment and Kevin saved my bacon. Thanks again everyone you guys rock.