LCN

[alphaacres]

The LCN number does not show for the control channel on the SDS 100,200 when using the option item LCN shows only voice.

 

[Whiskey3JMC]

Is said LCN programmed accordingly for said control channel in your favorites list?

 

[JethrowJohnson]

Are ya trying to program an LTR network or EDACS? I'm not sure about EDACS, but I know LTR doesn't use a dedicated control channel. Each frequency just transmits a short data burst every 10 seconds.

 

[dave3825]

P25 does not have anywhere to enter an LCN. It does display LCN while on a voice channel then goes back to --- after voice.

DMR however does have an LCN column in the sites.

 

[alphaacres]

Be nice if Uniden could fix this?

 

[dave3825]

Be nice if Uniden could fix this?

You have not stated where you are seeing this. Dmr or P25? If Dmr, do you have the correct lcn values entered in for each freq? P25 gets the info over the air on the control channel stream.

 

[Ubbe]

Be nice if Uniden could fix this?

It can't be fixed as the channel frequency itself does not transmit its own LCN info. The control channel data sends the LCN number of a voice channel when it informs where a TG conversation are taking place and also the LCN's of neighboring sites control channels but it doesn't inform of the frequency so you will have to figure out the bandplan, perhaps by using LCN finder.

/Ubbe

 

[dave3825]

channel frequency itself does not transmit its own LCN info.

That's on DMR , right?

 

[alphaacres]

P25 P1 LSM My Blue Tail Technologies P25RXII does control channel LCN the infomation has to be there for control channel LCN.

 

[JoeBearcat]

P25 has a standard plan so no broadcast is required. That said, the scanner can show the frequency if you have a field so set.