BCD996P2: Listen to programmed groups

Status
Not open for further replies.

Arrogate

Newbie
Joined
Aug 3, 2017
Messages
1
I have my frequencies programmed into my groups and that all seems good per a couple
Yotub3 videos I followed. But when I hit scan it defaults to a Public Safety channel with so:12. There is no SO:12 programmed. I have a so:1 and so:2. It wont scan my SO:1 Goup:1 just tries to scan this public safety channel. How do I delete this or ignore it or how do I get it to scan just what I programmed?
Thanks for your help.
 

ofd8001

Member
Premium Subscriber
Joined
Feb 6, 2004
Messages
7,112
Location
Louisville, KY
That line that begins with "S" indicates the status of System Quick Keys. What you are seeing translates into System Quick Key 1 is enabled and System Quick Key 2 is enabled.

The "0" is the first digit of the System Quick Key, in other words you technically have System Quick Keys 01 and 02 programmed and enabled. Had their System Quick Keys been 11 and 12, you would see "S1:12-------", and if they were 21 and 22 you'd see "S2:12-------"

If you disabled System Quick Key 1, you would see "S0:*2-------", the asterisk meaning the SQK is assigned but is disabled.

The line below that "S" line should say "GRP" which corresponds to the status of Group Quick Keys in a fashion similar to System Quick Keys.

Without seeing your exact programming, it's hard to see why you are having a problem.
 
Status
Not open for further replies.
Top