Portable Shack

Status
Not open for further replies.

Dark_Hunter

Member
Joined
Jun 12, 2018
Messages
97
Location
New Zealand
I don't really have a shack so I would share my radios I use instead. From left to right. My Tait TP8115 programmed for 2M ham radio bands. Middle, radio programed to scan radio with selcalling decoding displaying statuses. Far-right, radio programmed for Fire scanning with selcalling decoding.

ReHupYt.jpg
 

Dark_Hunter

Member
Joined
Jun 12, 2018
Messages
97
Location
New Zealand
Cant edit my thread, but here's something I have set up for use to monitor ambo and ham use.
5vl60DN.jpg


These are set up to monitor pocsag and ambo and record to disk, all private.
REIFCa0.jpg
 

Stupidfatkid

Member
Joined
Apr 26, 2004
Messages
170
Location
Kansas
Looks like you gained some elevation with the new location of the antenna. Are you receiving more aircraft? Looks like you switched from POE on the Pi to WiFi and standard micro USB power. I run my ADSB receiver on WiFi. Have you noticed any difference in the decoding accuracy switching to WiFi over being hardwired with a network cable?
 

Dark_Hunter

Member
Joined
Jun 12, 2018
Messages
97
Location
New Zealand
Hello, this is a new setup in another location entirely.

As for the WiFi I haven't noticed much difference in turns of decoding messages.

It would make sense to have to unit close to your router anyway witch it is.

Has for aircraft numbers I say I would get 24 on a good day.
 
Status
Not open for further replies.
Top