Bit of a long shot I'm sure but is there anyone out there that has a copy of the PSR-800 U1.8 CPU Firmware? Not even sure that exists by itself. I have a zip archive that contains the "Beta" U1.7 firmware package but I had 1.8 on both my PSR-800's. I am having an issue with Phase II and I think it may have been caused after I upgraded to the U2.0 firmware through EZ-Scan. I'm not 100% positive of that but I'd at least like to try U1.8 again to see if the problem goes away if that's even possbile. I downgraded to the U1.7 version that I had and that didn't make a difference.
PSR-800 U1.8 CPU Firmware Download
- Thread starter NC91
- Start date
- Status
DJ11DLN
Member
I don't have an answer to your question but I can say that if you send it to Whistler, for $60 they will convert it into a WS-1080, and it will perform a lot better than it did with the Grecom FW. It's money well spent.
cookmaster
Member
check this website out might be what you are looking for! GRE America Inc.
matthias_h
Member
- Joined
- Jul 10, 2013
- Messages
- 24
The firmware and DSP update are done through the EZ Scan software. It's still available at GRE America Inc. in the GRE PSR-800 section. After installation, a software update has to be performed that goes beyond the downloaded version. Then the setup is ready to connect to the scanner and update it. It is important to follow the scanner update instructions exactly, e.g. when to switch the unit on, off, etc.
mlhendersonnv
Newbie
- Joined
- Jan 23, 2008
- Messages
- 1
I'm concerned that if I send in my gre psr-800 will they take care not to damage or scratch it? I ask cause my scanner is in 100 percent perfect condition as I bought it when i was a gre dealer and I want it to stay in perfect condition.
frankdrebbin
Member
I sent my PSR 800 in last year for the upgrade. Money well spent. It works great and no they didn't scratch it.
Cbman417
Member
How long was the turn around time?
Others posted in other places 2 weeks some shorter some longer.
Cbman417
Member
Thank you
frankdrebbin
Member
I remember around 2 weeks. Been working just fine. I needed to get it upgraded to Phase II.
Cbman417
Member
Should receive phase one and two
- Joined
- Feb 18, 2016
- Messages
- 1,914
PSR-800 Had phase 2 from the day it was built. Legacy upgrade adds DMR and dozens of firmware fixes and improvements. Plus you get to use the still update ezscan for the ws1080 with all its improvement and you get any future improvements to firmware and ezscan.
fourwd1
Member
No it did not.
GRE released a Beta version firmware upgrade for Phase II shortly before they closed up. Some late models may have shipped with that
fourwd1
Member
and the Radio Shack version did come with P II
Cbman417
Member
No, you're Wrong Prs-800 did come with phase 2, mine did,I sent it in to Whistler for the dmr upgrade. Work better than before.
- Joined
- Feb 18, 2016
- Messages
- 1,914
- Joined
- Feb 18, 2016
- Messages
- 1,914
If yours did, you bought it used or it was a returned product that someone else updated with the experimental beta firmware before they returned it. Read the info at the link Wackyracer posted.
The 800 did not come with any form of Phase 2 support from the factory as it was still a beta release afaik.
- Status
