repeater ENLN4055 with GM950N2

[Cajou]

Hello friends,

First post here and first motorola hardware of my life 😉 I got a full repeater ENLN4055 with GM950N2.

After a few setbacks with various cables, I ended up making myself a batlabs interface that works perfectly. I can use the TRICK software and the RSS for reading tranceivers and interface.

I got the working frequencies but I have the impression that the previous owner "cleaned up" the settings (403MHz set). I used a VNA in order to get working frequencies from the diplexer. I entered correct high and low frequencies with a TCS. No ouput. The receiver red led light on,

I isolated receiver (no rear connection from trick) and try with speaker on, I ear noise. But when I transmit from a portable, radio become silent with red led frequency busy on. Seems to works backwards.

I'm now that the repeater is working but I'm not entering the right settings. 😂

I would like to succeed both in learning more about motorola and then to give this relay to an association of rescuers.

What can I do next ?

I'm open to any help. Thanks

 

[KevinC]

Before anyone complains about the frequency, the OP is not in the US.

 

[Cajou]

Thank you for clarifying 👍 I use a dummy load and I will use private legally assigned frequency for this group of rescuers.
All things are clear... except GM950 setup !

 

[Cajou]

Hello,
I contacted Motorola representative to check if I had the right software version and if so, to buy.

The answer is interesting:
we can't help you because these models are no longer supported. We no longer have any information or release on our servers.
How do I get them? "Take them on the internet." 🧐

fortunately there are sites like radioreference !!!