Is there a way I can connect multiple antennas to one run of LMR400 coax?
Reverse Multicoupler?
- Thread starter JamesBrox
- Start date
- Status
mmckenna
I ♥ Ø
If the antennas are for different bands, you want a Diplexer or Triplexer depending on your exact application.
If the antennas are the same band, then it gets tricky and there really isn't one off the shelf product that will work.
You can do some interesting things with diplexers/triplexers with having different band radios on one end, common coax in between, and different band antennas on the far end.
- Joined
- Jan 5, 2003
- Messages
- 14,115
- Reaction score
- 10,006
- Location
- Retired 40 Year Firefighter NW Tenn
I am working on 150mhz 460mhz 700 800mhz beams on a ham iv rotor at 50 feet.
Ubbe
Member
Duplexers are often filters to handle two frequencies in the same band and combine them to one coax and are often very narrow banded. Diplexers are refering to two frequencies in different frequency bands that are combined. There are even triplexers that handle three different frequency bands.
/Ubbe
/Ubbe
- Joined
- Dec 19, 2002
- Messages
- 2,706
- Reaction score
- 1,575
Assuming you are going to use the antenna for different bands, other responses will address that telling you about using diplexers to do that. If you are trying to use it for receiving and transmitting on a single band,, Ubbe's response about duplexers addresses that. But if you are thinking you can use more than one antenna to improve reception on one band, you have a can of worms. This is because the phase of the signals are as likely to weaken your signal as they are to strengthen it unless the spacing of the antennas and signal direction is addressed for that frequency---you really do not want to go there.
iMONITOR
Silent Key
Diplexers have a lower insertion loss vs duplexers.
A diamond discone and a 700-900 MHz yagi
mmckenna
I ♥ Ø
iMONITOR
Silent Key
A little better price here: ($59.95)
Diamond MX37 Duplexer
Diamond MX37 Duplexer Diamond MX37 Duplexer Port: LPF/HPF Frequency (MHz): 1.6-470/900-1300 CW W: 100/50 PEP W: -/- Loss dB: .25/.45 Isol dB: 45/45 Mix Connector: N-Jack (f) Port connector: PL259 + 12" 5D
www.gigaparts.com
- Status
Similar threads
