SDRTRUNK detection problem of Trunked P25
- Thread starter ronenp
- Start date
Try adjusting the PPM on your tuner(s).
The PPM is correct the signal is exectly on the pass band of the spectrum when i moove to 06/12 nightly or before it work everything after this build is not working it sometimes detect control channel for a second
i tested it with 2 diffrent RTL-SDR one with e4000 tuner and one V3 and on two diffrent computers same results when i roll back to 06/12 nightly it start to work correct
i tested it with 2 diffrent RTL-SDR one with e4000 tuner and one V3 and on two diffrent computers same results when i roll back to 06/12 nightly it start to work correct
32dave
Member
I am having the same problem its not reading the data channel properly also the last two nightly's have killed DMR. I am getting every other syllable I was waiting to get all the info together to post on the group
this is the system Land Mobile Radio Network (South Zone) Trunking System, Multiple Locations, Ontario p25phase two (about 4 months old) and this is the DMR Oxford County, Ontario (ON) Scanner Frequencies and Radio Frequency Reference county fire. I can attach video and pictures if needed just going to take a bit to get together
this is the system Land Mobile Radio Network (South Zone) Trunking System, Multiple Locations, Ontario p25phase two (about 4 months old) and this is the DMR Oxford County, Ontario (ON) Scanner Frequencies and Radio Frequency Reference county fire. I can attach video and pictures if needed just going to take a bit to get together
Last edited:
Also had same issue with past two nightly releases. Neither Conventional or Trunked P25 working, even tried adjusting PPM, only NBFM worked. I reverted back to Dec 6, 2024 release which works fine.
So am I, it locked up 5 seconds after it loaded, rolled back to nightly12-06 version which had worked great, and now get no audio on a trunked system.
Rolled back to 0.6.1 still no audio on trunked system. Reset Vectors, reset jmbe library, still no audio on trunked systems. Had to revert feed back to the SDS200 till I figure it out.
Update: Reinstalled nightly 12-06 again, reset everything, rebooted computer and now back to working. Think I will lay off the nightly updates for a while since the last three have not worked on my two computers.
Rolled back to 0.6.1 still no audio on trunked system. Reset Vectors, reset jmbe library, still no audio on trunked systems. Had to revert feed back to the SDS200 till I figure it out.
Update: Reinstalled nightly 12-06 again, reset everything, rebooted computer and now back to working. Think I will lay off the nightly updates for a while since the last three have not worked on my two computers.
Last edited:
Similar threads
