SDS100/SDS200: SDS 100 and DMR T3 programming

[dcs00]

I am trying to find a tutorial or step by step instructions to either use Sentinel or manually a DMR T3 system on an SDS 100.
This is the system a regional energy company called Evergy I would like to monitor during storm events.
I have not been able to figure it out ? Any help would be appreciated so I can get it up to start finding the LCNs and TGs.

Evergy (DMR T3) Trunking System, Various, Multi-State

Thanks

David Stearns

 

[hiegtx]

I am trying to find a tutorial or step by step instructions to either use Sentinel or manually a DMR T3 system on an SDS 100.
This is the system a regional energy company called Evergy I would like to monitor during storm events.
I have not been able to figure it out ? Any help would be appreciated so I can get it up to start finding the LCNs and TGs.

Evergy (DMR T3) Trunking System, Various, Multi-State

Thanks

David Stearns

It's listed in the main database in Sentinel. You can open the database in Sentinel, then go down to Kansas, and then your county, Johnson.
The system is listed there. If you <right><click> on it, you can append that system to a Favorites list to be scanned. Doing that append, that will include all of the sites in various counties. You can use Location control to limit scanning to only the sites in range. Or, use location control so that only the ones in range will be scanned. Or, delete the out range sites to that only the ones closest to you are scanned.