I recently updated my shack with a new PC and its right above the power supply on right hanging on wall. Its an HP elitedesk that I got from my Brother. It has an NVME ssd, 16GB ram, and all my radio software on it. Runs nice. I was formerly using an HP Z420 server that we set up for scanner/ham radio. But I have it sold cause it was just too big and I needed space for power supply. There is another computer on opposite side of desk, an HP Z210 with MX Linux which also runs some ham radio and scanner software. I plan to replace this PC with another HP elitedesk with similar specs to get a little more space on desk.
On left is scanner rack with SDS200, BCD996P2, BCT15X and an IC 2730. To the right is IC 7300 on a small plastic shelf. Under the 7300 is an LDG AT-200 pro tuner. To the right of that is a CB radio with meter and tuner on top. Then way over is Astron 35M power supply. I use an OMNI-X for the 2 middle scanners on rack and the 2 SDR's hanging on wall. A Stridsberg multi coupler connects these from 1 antenna. The SDS200 has an 800 mhz yagi outside on gutter pointing east. And the IC 7300 uses an old G5RV out in backyard.
On left is scanner rack with SDS200, BCD996P2, BCT15X and an IC 2730. To the right is IC 7300 on a small plastic shelf. Under the 7300 is an LDG AT-200 pro tuner. To the right of that is a CB radio with meter and tuner on top. Then way over is Astron 35M power supply. I use an OMNI-X for the 2 middle scanners on rack and the 2 SDR's hanging on wall. A Stridsberg multi coupler connects these from 1 antenna. The SDS200 has an 800 mhz yagi outside on gutter pointing east. And the IC 7300 uses an old G5RV out in backyard.
