Hello,
I am trying to program some 700 MHz band frequencies (to monitor/scan) into my XTS5000. However, the program shows the RCV and TX frequency as red (as an error). I want it to be RCV only (I know how to to that), but I read in previous posts I need to put in the TX frequency first, the proper deviation (I set it to 2.5 kHz, but regardless the setting I get the same problem), and then set it to RCV only mode.
I am not sure what I am missing. I have read as many posts as I can find on the subject (not many; one of them shows the questions and some advice, the the OP says he figured it out but doesn't say what he did to fix it), watched a YouTube tutorial, and followed the advice on all of them, but still cannot seem to enter in any 700 MHz frequencies. Oh, and yes, I checked at the post-test, the radio is 700/800 MHz. By the way, 800 MHz band frequencies don't present this problem.
Any help is much appreciated.
I am trying to program some 700 MHz band frequencies (to monitor/scan) into my XTS5000. However, the program shows the RCV and TX frequency as red (as an error). I want it to be RCV only (I know how to to that), but I read in previous posts I need to put in the TX frequency first, the proper deviation (I set it to 2.5 kHz, but regardless the setting I get the same problem), and then set it to RCV only mode.
I am not sure what I am missing. I have read as many posts as I can find on the subject (not many; one of them shows the questions and some advice, the the OP says he figured it out but doesn't say what he did to fix it), watched a YouTube tutorial, and followed the advice on all of them, but still cannot seem to enter in any 700 MHz frequencies. Oh, and yes, I checked at the post-test, the radio is 700/800 MHz. By the way, 800 MHz band frequencies don't present this problem.
Any help is much appreciated.
Last edited: