No audio coming through Scanner Cast V0.14

[JoshuaHufford]

For some reason even though the software says it is connected and running, no audio from my scanner is going to the feed. I know for a fact that audio from my scanner is getting into my PC, if I listen to it directly from the windows sound devices I hear it fine, but listening on the feed, there is nothing but an occasional click. I have the proper audio device selected, I've tried a different audio device, and I've rebooted the PC with no change.

I'm stumped. Any ideas? The same setup has worked fine for over a year.

 

[JoshuaHufford]

Well I was able to figure this out. Apparently my audio cable failed and was only supplying audio one of the 2 audio channels, and I guess ScannerCast only uses one audio channel even when not in stereo mode, and it was trying to get audio from the dead channel. New audio cable fixed the problem.

 

[gmclam]

Keep in mind that what you hear on your PC comes through "Playback properties" while what goes to ScannerCast is through "Record Properties". In there you can set levels, etc.

 

[JoshuaHufford]

Yes I was on the Recording Properties.