mount

So here is what i want to do, i have two antennas that i want to mount one is a discone and the other is a j pole and what i am trying to do is use a piece of pipe that is no bigger than 1' 3/8 in diameter and put the discone ontop of the pipe and midway's down attach the j pole i have already...

One of our departments bought some new Mac roll off trucks that comes pre-wired for a CB. Is anyone aware of an adapter to convert the CB antenna mount to an NMO for our commercial radios? There is not enough slack in the coax to solder on an NMO, and I'm looking for a simpler solution that...

I purchased an SDS200 and wanted to mount it using the DIN Slots in my Subaru dashboard. I could not find much info on the forum or generally online. So, I made a short video of my experience. Hopefully, it helps someone out. Radio: Uniden SDS200 Vehicle: 2003 Subaru Outback Antenna: NMO Roof...

Hello I’ve been shopping antennas for the past few days for my mobile rig, Anytone AT 778 UV. I have so many choices I have stalled my decision. Hoping someone has sage advice and recommendations for the 2 and 70 while also allowing GMRS when plugged into my GMRS radio. I saw this one on Amazon...

Hi everyone, Does anyone use or know of any cup holder type holders for the XG-100P? I place my radio in my cup holder often but it moves around a lot, especially when going around corners and such. I’ve seen many 3D printed cup holder stands for other radios and scanners, but I haven’t been...

I have a 4th Generation 2019 Chevrolet Silverado and needing to see what mounts are available for the Hand rail. Might mount two remote heads, if can find good mounts. Thank you Ken

I'm looking to install a base station in my house. I looking at possibly using and old adjustable Directv wall mount and a few links of mast to raise a Anton 99 over the low edge of my roof line. My question is since I have a metal roof, and the peak of that roof will be higher than about 50%...

I just finished up a faceplate and mount build and thought I should share this for others. I know, it’s nothing special but maybe it will help or encourage somebody. I was originally planning on using a Havis faceplate / radio mount but they seemed to be sold out everywhere and I...

I was up crawling around the attic yesterday making some additions and changes to my setup. I had an OCFD laying up there being unused. I had built it a while ago and used it for a short time. I ran some RG-6 to that and place it on the far end of the attic. My current attic mounted antenna...

Hello, I just received my 4' Firestik Firefly fiberglass antenna in thr mail today and was considering mounting options for my '01 Toyota Tacoma. Asthetically, the best looking spot for it is attached to the walls of my trucks bed, however, the bed has been covered in a nice spray bed liner ever...

I live in a condo complex where no External antennas are allowed. I want to mount a Laird 9db gain yagi antenna indoors (no attic) somehow but can't figure out how to do this so it stays pointed towards the 800mhz systems I want to monitor 30-40 miles away. Any ideas? PS I am using a BCD436HP...

Hi everyone, Anyone have any ideas on where I could purchase some type of magnetic mount/ device which could hold or includes a short pole to mount a yagi antenna on top of a car? (Don't worry- the car will not be moving!) The yagi antenna itself is only 18 inches. I have searched high and...

For the small portable scanner that I keep in my Jeep Liberty I wanted to mount a remote speaker closer to my ears. After thinking about if for a while I found a location and made a little clip mount. As per usual here's a little video of the build and mounting. Remote Speaker for Scanner -...

Hello all, I'm new here. I have been a General licensed ham for 20 years and used to be somewhat active on the bands. Then life took over...marriage, kids, job, etc. I'm slowly getting back into the hobby. I've always enjoyed CW as well as other modes and want to get back into those. I...

I want to mount an antenna to the rear bumper of my 2000 dodge caravan. It will only be used when the van is still, I will not have it up while the van is in motion. Here is a link to an antenna that is very close to what I have. Antennacraft? Colorstar C290 HDTV/VHF/UHF/FM Antenna : Outdoor...

Could anyone please advise me about the system that the local police and SO are now using? I am still receiving fire/ems conventional.

Hey guys. Need some suggestions. I have two VHF Mobile Radios in which I transmit on both. I already have the Coax run. These will be mounted on my chimney and would prefer that both be mounted on the same mast. What items will I need? The chimney itself is maybe 5 feet tall. The current...

I would like to mount my Radio Shack Pro-433 in my 2003 Cadillac STS, but I have no idea where to put it. Has anyone done this before, and if so could you maybe let me know where you mounted it any possible send pictures? jaredkoester@gmail.com Thanks, Jared2295

All, While this is my first time posting in the antenna forum, it's not my first reading the posts. I appreciate all the inputs everyone has given. I've learned an immense amount of knowledge from all of your contributions. Unfortunately, I haven't learned enough and need a little help! :)...