BD200W
Member
Far from Complete, attached is the Confirmed and in Use Frequencies and Tone codes used by the USF Series at Portland over the Weekend. If the Name of the Driver isn't mentioned or the Position they are Running at isn't heard over the Radio, it's hard to figure out who is Driving so there are a few empty Confirmations to fill in if Possible.Awesome, thank you very much, I will definitely have a look over this. I appreciate this very much.
I tend to use my 436 in conventional discovery mode from 450-470 mhz. Lately I've been able to figure out how to do a discovery mode and just name each one different for each series. Has worked well so far. I don't tend to really have much time though to try and put names to channels/frequencies found unfortunately due to my role there. I may or may not even have a chance to do some scanning/searching. But if I do, anything gathered ahead of time is a plus for less programming to have to do while on the go. Re-progamming/re-organizing doesn't get done, if done at all, until I get home for the night.
Is there a spot onsite to buy a list at a local scanner/radio comms type trailer?
A Couple Updates from Indycar, Alternate Frequencies/TC's were used by Car 7 (459.7750/311) and Car 60 (454.5000/243). Car 20 used 457.6750 with T/C 532. At Portland, the TV Audio Broadcast 450.6000 was the best Frequency for Audio Quality.
For the next IndyNXT Series Race on the Schedule, Car 8 was using 457.2250/165
I did not seek out any Purchase Options for Scanner Frequencies at the Track. Racing Electronics used to be the Comms Provider and they may have had Frequency Sheets in the Past but most Likely it would be for the Indycar and IndyNXT series only.
That's it for now.
BD