396xt issue HELP

Status
Not open for further replies.

jeffreyinberthoud

Completely Banned for the Greater Good
Banned
Joined
Oct 18, 2001
Messages
1,880
Reaction score
0
Location
BERTHOUD COLORADO
I somehow managed to get the hold locked and I can not get it to unlock no matter what site it is scanning its in system hold HELP

i TRIED RELOADING MY PROFILE FROM MY ARC-XT SOFTWARE AND IT JUST HOLDS ON THE LAST SYSTEM ENTERED:evil:
 

Dewey

Member
Joined
Dec 19, 2002
Messages
1,065
Reaction score
59
While scaning the system that is holding, hold down the [Hold] key for approx 3 seconds... you will hear a single beep, and the flashing "HOLD" in the display should disappear.

Dewey
 

jeffreyinberthoud

Completely Banned for the Greater Good
Banned
Joined
Oct 18, 2001
Messages
1,880
Reaction score
0
Location
BERTHOUD COLORADO
got it thanks it was in systenm hold not sure hoqw it got there I use site hold but not system hold guess it yet another feature Ill have to learn thanks for the help
 

MarMatthias

Member
Joined
Jul 13, 2010
Messages
202
Reaction score
1
Location
Nebraska
got it thanks it was in systenm hold not sure hoqw it got there I use site hold but not system hold guess it yet another feature Ill have to learn thanks for the help

If it happens again and system that seems to "stick" (won't un-hold), try pressing the HOLD button to hold on a single channel, then press HOLD until the scanner reads "System Hold Off". I had this happen to me when I was learning the basic keys and I inadvertently locked out a control channel. Probably co-incidence, but it worked...
 
Last edited:
Status
Not open for further replies.
Top