ARC125: ARC125 Virtual Scanner Display Shows Only Dashes

[gskroll]

I am able to read/write to the 125 via ARC125 software - the software detected COM6. However, the "virtual" display of scan status from the scanner is not reflected in the ARC125 software.
Instead, the virtual display shows only 7 rows of "- - -" along with the expected set of virtual buttons.

I have uninstalled/reinstalled ARC125. I have installed the Uniden Serial Drivers as instructed in the ARC125 doc from C:\Program Files (x86)\BuTel\ARC125.

What do I need to do to get this working?

Thanks!

Glenn

 

[Whiskey3JMC]

Hi there:
My thinking is this question would be better suited for the Scanner Programming Software forum. If you don't get a relevant response here in Uniden Tech Support, feel free to click the Report link at the bottom of your posting and ask for this thread to be relocated to the one I linked (please don't double-post same question in aforementioned forum). Best wishes!

 

[gskroll]

Hi there:
My thinking is this question would be better suited for the Scanner Programming Software forum. If you don't get a relevant response here in Uniden Tech Support, feel free to click the Report link at the bottom of your posting and ask for this thread to be relocated to the one I linked (please don't double-post same question in aforementioned forum). Best wishes!

That makes sense - I should have recognized that myself <g>.
Thanks for the suggestion.
Glenn

 

[Butelsoftware]

Click the VC setup tab and then select the correct usb/com port and click Start. You can also select Autostart.

Gommert
www.butelsoftware.com

 

[gskroll]

Thanks for the quick response. I missed that the virtual display had history and setup tabs - VERY bad eyesight.