BCD325P2/BCD996P2: Aunt Lo's Supply Co Scanner Cradle

[sunwave]

I just ordered and received a cradle for my BCD325P2 on Amazon. The product page says manufactured by Aunt Lo's Supply Co. The scanner fit snug and it is stable. It is really nice. It has a slight angle back making the scanner's display easy to see. Both sides of the cradle stop just below the menu and E key which is far enough to keep the belt clip on. It was worth the $15.99

Amazon.com: Stand for Bearcat BC125AT BCD325P2 - Secure Desk Mount Handheld UHF Radio, Police Scanner, Vehicle Electronics, Table Use - 10° Tilt Easy Display - Durable Design Includes Screw - Made in USA : Office Products

Amazon.com: Stand for Bearcat BC125AT BCD325P2 - Secure Desk Mount Handheld UHF Radio, Police Scanner, Vehicle Electronics, Table Use - 10° Tilt Easy Display - Durable Design Includes Screw - Made in USA : Office Products

www.amazon.com

 

[garys]

I have a stand, which I think was originally for my 436HP, but the 325P2 fits in loosely. I also have to remove the belt clip to use it. This seems like it would be much better and that is a good price.

Thanks.

 

[sunwave]

I have a stand, which I think was originally for my 436HP, but the 325P2 fits in loosely. I also have to remove the belt clip to use it. This seems like it would be much better and that is a good price.

Thanks.

A few of the images on the Amazon seller page look to be of an older version with a screw hole to secure it on a desk. The version you will get is the first image. It comes with four 3m rubber feet to stick onto the bottom of the cradle. No screw hole. I think you might be satisfied with it.

By the way, I test fitted the BC75XLT and it fit snug as well. I do not have any more scanners to test fit. Theoretically judging by the form factor of these following models, SR30C, and BCD160DN should also fit.

 

[garys]

I think it will word well for me, including the rubber feet.

A few of the images on the Amazon seller page look to be of an older version with a screw hole to secure it on a desk. The version you will get is the first image. It comes with four 3m rubber feet to stick onto the bottom of the cradle. No screw hole. I think you might be satisfied with it.

By the way, I test fitted the BC75XLT and it fit snug as well. I do not have any more scanners to test fit. Theoretically judging by the form factor of these following models, SR30C, and BCD160N should also fit.

 

[sunwave]

I have finally found the time to post the scanner in this cradle.