BC125AT: BC125AT Direct Entry

[ScanRafael]

Is it possible to directly enter a frequency on the BC125AT?
For example, on my BCD436HP, SDS100, and SDS150 I can hold on a conventional channel, enter a frequency using the keypad, and then press “channel” and the scanner will immediately tune to the frequency that I entered.
Is it possible to do this with the BC125AT? If so, how?

 

[D31245]

Yes. Similar (not same) sequence.

1. Press Hold
2. Enter frequency from keypad
3. Press Hold again

From Page 47 of the manual:

https://www.uniden.info/download/ompdf/BC125ATom.pdf

 

[D31245]

The above works for both programmed channel numbers and direct frequency input.

 

[wtp]

the difference is the decimal point,
with it, it listens to a frequency
without it, it goes to a channel