I have been able to get everything setup with two RTL-SDR dongles listening to the Fort Bend County TX P25 simulcast of TxWARN, however when I send the audio over to DSD+ via virtual audio cable all I end up hearing is garbled traffic. When data goes over to DSD+ it says
Sync: no sync
Sync25p1 NAC:1A3 TDU
Sync25p1 NAC:1A3 TDULC
Sync25p1 NAC:1A3 TDULC
Sync25p1 NAC:1A3 TDULC
...
...
...
...
Sync25p1 NAC:1A3 TDU
Sync25p1 NAC:1A3 HDU
Sync: no sync
It will also give the lines
Sync25p1 NAC:1A3 LDU2 e:9rFr21Er3Er
Sync25p1 NAC:1A3 LDU1 erCrCrCrCrCrCr
I haven't had any problems listening to the Fort Bend County TxWARN motorola simulcast, which I haven't even had to pass over to DSD+ to listen to.
Am I missing something here? I feel like I have read a lot on the software but haven't found anything that would suggest I missed a step. Thanks in advance for helping.
Sync: no sync
Sync25p1 NAC:1A3 TDU
Sync25p1 NAC:1A3 TDULC
Sync25p1 NAC:1A3 TDULC
Sync25p1 NAC:1A3 TDULC
...
...
...
...
Sync25p1 NAC:1A3 TDU
Sync25p1 NAC:1A3 HDU
Sync: no sync
It will also give the lines
Sync25p1 NAC:1A3 LDU2 e:9rFr21Er3Er
Sync25p1 NAC:1A3 LDU1 erCrCrCrCrCrCr
I haven't had any problems listening to the Fort Bend County TxWARN motorola simulcast, which I haven't even had to pass over to DSD+ to listen to.
Am I missing something here? I feel like I have read a lot on the software but haven't found anything that would suggest I missed a step. Thanks in advance for helping.