Hi, I have signed up for fastlane today. Got DSD+ 2.256 setup, and my audio input correctly selected as the Audio CODEC presented by the yaesu (over usb) in Win10. I see the audio appear in the graph window when someone transmits DMR on the currently selected frequency (I have the yaesu on FM on WIDE (16k), but get no decoding happening. All I get is the encoded audio from the radio come out of the laptop speaker.
Started the app with the -rp switch (otherwise the input shows as greyed out, and defaults to network input only)
I have control set to 'passive digital monitor'
My input set to Microphone Audio CODEC (this is the Yaesu input)
Input, 'Monitor source audio if no sync and signal present' is selected (I tried them all)
Output, 'Synthesize All Digital Voice' is selected
Decoder, 'Decoding polarity auto detect', 'Decode DMR' selected
Not even attempting to decode the digital audio. Any advice would be great, thanks, Paul
Started the app with the -rp switch (otherwise the input shows as greyed out, and defaults to network input only)
I have control set to 'passive digital monitor'
My input set to Microphone Audio CODEC (this is the Yaesu input)
Input, 'Monitor source audio if no sync and signal present' is selected (I tried them all)
Output, 'Synthesize All Digital Voice' is selected
Decoder, 'Decoding polarity auto detect', 'Decode DMR' selected
Not even attempting to decode the digital audio. Any advice would be great, thanks, Paul
Last edited: