pro 106

[VE3JSO]

i am trying to program fleetnet in my scanner pro 106 and i know i have to go to the globe settings but i can't find where it says band plan can any one help me with that

 

[Tdog50]

Your question is a little vague. are u using a program or are you trying to program manually ?

 

[VE3JSO]

trying to do by hand i looked for it could not find it when i try to program with out changeing settings in globe menu i type in 142.71000 then scanner put in 142.71500

 

[bill67]

Pro 106 programmingi

If your scanner is new BANDPLAN is in GLOBAL menu. If it is older follow FORTS sticky at top of page. Hope this helps ( I had same problem ) BILL67

 

[VE3JSO]

yea i was looking in the globe menu and i could not find the bandplan where did you see bandplan on yours bill? i bought the scanner yesterday and i checked the scanner firmware before i did anything and it looked like the updated firmware but i just used win500 to program it.

 

[bill67]

Check out Dec. 27 thread by Doggy 1 and follow it down to where Forts gives rundown on how to program fleetnet into the 106. I did one for my brother-in-law before Christmas so I do not have manual to check. There are different GLOBAL menus for each type of object you choose i.e. Conv. object, Talkgroup object . When Forts checks in he will set you straight. Good Luck. BILL67

 

[VE3JSO]

for the ac adapter i picked up 9V 800mA with the type c plug would that bo ok i read the book that came with it and it said at least 500mA i just don't want to damage my scanner

 

[Forts]

That adaptor will be fine.

 

[VE3JSO]

thanks for the help